Creep
The creep test loads a sample a given amount then maintains the load while monitoring a increase in position.
Parameters
Load Limit: the target load for the creep test
Time to Run: Total time, including initial loading, the test will run.
Known Issues
The motor will tend to bounce going in and out while attemping to maintain the load. Changing the min PWM in advanced settings may fix this. The time isn't the time to hold the given load, it is a total time. The motor could leave the LVDT range.
Except where otherwise noted, content on this wiki is licensed under the following license:CC Attribution-Noncommercial-Share Alike 3.0 Unported
