This shows you the differences between two versions of the page.
classes:principlesofdesign:cncmechanicaltester:physical [2011/03/21 21:45] nmuir created |
classes:principlesofdesign:cncmechanicaltester:physical [2011/03/21 21:54] (current) nmuir |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | Below may be viewed the set up created for the SRL test simulation given in the video above: | + | ====== Physical Components of Mechanical Tester ====== |
+ | |||
+ | **Watch this SRL and Dynamic test [[http://www.youtube.com/watch?v=eJCR3f0xQCY|in progress]] to see the functionality of each component pictured below:** | ||
{{:classes:principlesofdesign:cncmechanicaltester:spindle1.jpg|}} | {{:classes:principlesofdesign:cncmechanicaltester:spindle1.jpg|}} | ||
- | * This is the spindle for the Roland MDX - 540 CNC Machine we are using. Attached below it is the load cell attachment, which is connected to the Data Acquisition Board. | + | **This is the spindle for the Roland MDX - 540 CNC Machine we are using. Attached below it is the load cell attachment, which will be connected to the Data Acquisition Board.** |
{{:classes:principlesofdesign:cncmechanicaltester:daq1.jpg|}} | {{:classes:principlesofdesign:cncmechanicaltester:daq1.jpg|}} | ||
- | + | **Above is the output value from the load cell.** | |
- | * Here is the output value from the load cell. | + | |
{{:classes:principlesofdesign:cncmechanicaltester:software1.jpg|}} | {{:classes:principlesofdesign:cncmechanicaltester:software1.jpg|}} | ||
- | * Shown here is the proprietary software for the Roland MDX - 540. | + | **Shown above is the proprietary software for the Roland MDX - 540.** |
{{:classes:principlesofdesign:cncmechanicaltester:setup1.jpg|}} | {{:classes:principlesofdesign:cncmechanicaltester:setup1.jpg|}} | ||
- | * The set up without the 'control tower' box may be seen here. | + | **The set up without the 'control tower' box may be seen here.** |