Physical Components of Mechanical Tester

Watch this SRL and Dynamic test in progress to see the functionality of each component pictured below:

This is the spindle for the Roland MDX - 540 CNC Machine we are using. Attached below it is the load cell attachment, which will be connected to the Data Acquisition Board.

Above is the output value from the load cell.

Shown above is the proprietary software for the Roland MDX - 540.

The set up without the 'control tower' box may be seen here.

classes/principlesofdesign/cncmechanicaltester/physical.txt · Last modified: 2011/03/21 21:54 by nmuir
Except where otherwise noted, content on this wiki is licensed under the following license:CC Attribution-Noncommercial-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki