This is an old revision of the document!
Below may be viewed the set up created for the SRL test simulation given in the video above:
* This is the spindle for the Roland MDX - 540 CNC Machine we are using. Attached below it is the load cell attachment, which is connected to the Data Acquisition Board.
* Here is the output value from the load cell.
* Shown here is the proprietary software for the Roland MDX - 540.
* The set up without the 'control tower' box may be seen here.
Except where otherwise noted, content on this wiki is licensed under the following license:CC Attribution-Noncommercial-Share Alike 3.0 Unported
