Differences

This shows you the differences between two versions of the page.

start:classes:principlesofdesign:prototyping [2013/04/26 03:14]
jviola created
start:classes:principlesofdesign:prototyping [2013/05/07 22:29] (current)
jviola
Line 1: Line 1:
=====Prototyping===== =====Prototyping=====
-We 3D printed to solidworks model of the second speedy capper iteration, and produced this lovely pink piece to work with as an uncapper. Although crude, it can wedge caps with success without the addition of a groove or rubber stopper material to help fix the cap. We still plan to modify this tube and order springs.+We 3D printed to solidworks model of the second speedy capper iteration, and produced this lovely pink piece to work with as an uncapper. Although crude, it can wedge caps with success without the addition of a groove or rubber stopper material to help fix the cap. We still plan to modify this tube and order springs.\\ 
 +The model printed is the Speedy Capper D2 model, and we gained a lot of information from this model, which was considered in the [[start:classes:principlesofdesign:SCD3| Speedy Capper Design 3 ]] model.
{{:start:classes:principlesofdesign:img_2049.jpg?450x600| Speedy}} {{:start:classes:principlesofdesign:img_2049.jpg?450x600| Speedy}}
{{:start:classes:principlesofdesign:img_2048.jpg?450x600| Capper}} {{:start:classes:principlesofdesign:img_2048.jpg?450x600| Capper}}
 
start/classes/principlesofdesign/prototyping.txt · Last modified: 2013/05/07 22:29 by jviola
 
Except where otherwise noted, content on this wiki is licensed under the following license:CC Attribution-Noncommercial-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki