This shows you the differences between two versions of the page.
|
classes:principlesofdesign:cncmechanicaltester:test_and_terms [2011/03/21 21:38] nmuir |
classes:principlesofdesign:cncmechanicaltester:test_and_terms [2011/03/21 21:46] (current) nmuir |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| * __Dynamic__ - This test oscillates the load cell at a given frequency and monitors the load on the sample. This simulates the constant wear and tear on a sample such as a knee replacement. | * __Dynamic__ - This test oscillates the load cell at a given frequency and monitors the load on the sample. This simulates the constant wear and tear on a sample such as a knee replacement. | ||
| - | Below may be viewed the set up created for the SRL test simulation given in the video above: | ||
| - | {{:classes:principlesofdesign:cncmechanicaltester:spindle1.jpg|}} | ||
| - | |||
| - | * This is the spindle for the Roland MDX - 540 CNC Machine we are using. Attached below it is the load cell attachment, which is connected to the Data Acquisition Board. | ||
| - | |||
| - | {{:classes:principlesofdesign:cncmechanicaltester:daq1.jpg|}} | ||
| - | |||
| - | |||
| - | * Here is the output value from the load cell. | ||
| - | |||
| - | {{:classes:principlesofdesign:cncmechanicaltester:software1.jpg|}} | ||
| - | |||
| - | * Shown here is the proprietary software for the Roland MDX - 540. | ||
| - | |||
| - | {{:classes:principlesofdesign:cncmechanicaltester:setup1.jpg|}} | ||
| - | |||
| - | * The set up without the 'control tower' box may be seen here. | ||
| - | |||
| - | |||